1Kg Ferric chloride anhydrous FeCl3 96% Powder PCB Etching

1Kg Ferric chloride anhydrous FeCl3 96% Powder PCB Etching

Important Information

• Add the dry powder little-by-little to a larger volume of water.
• Ferric Chloride produces a great deal of heat when wet.
• Never add water to the powder.
• Ferric Chloride will also fume in moist air.
• It is highly hygroscopic and can absorb enough moisture from the air to dissolve itself into a liquid.
• Ferric Chloride Anhydrous (FeCl3) is commonly used as an etchant.
• To make a powerful etching solution for Damascus knives, add 150-300grams of Ferric Chloride to 1 litre of distilled water.
• Etching speed will depend on concentration, temperature, and agitation.
• Classification: CHLORIDE
• Type: FERRIC CHLORIDE
• Molecular Formula: FeCl3
• Standard: Industrial Grade
• Purity:96%min
• Application: Industrial
• Colour: Black
• Molecular weight: 162.204
• Density:2.8 g/cm³

Hazard statements

• H290 May be corrosive to metals
• H302 Harmful if swallowed
• H315 Causes skin irritation
• H317 May cause an allergic skin reaction
• H318 Causes serious eye damage
• Precautionary statements
• Precautionary statements - prevention
• P280 Wear protective gloves/eye protection.

Exposure controls

Use safety goggle with side protection.

Skin protection

1- Hand protection:

• Wear suitable gloves.
• Chemical protection gloves are suitable, which are tested according to EN 374.
• For special purposes, it is recommended to check the resistance to chemicals of the protective gloves mentioned above together with the supplier of these gloves.
• The times are approximate values from measurements at 22 ° C and permanent contact. Increased temperatures due to heated substances, body heat etc. and a reduction of the effective layer thickness by stretching can lead to a considerable reduction of the breakthrough time.
• If in doubt, contact manufacturer.
• At an approx. 1.5 times larger / smaller layer thickness, the respective breakthrough time is doubled / halved.
• The data apply only to the pure substance.
• When transferred to substance mixtures, they may only be considered as a guide.

2- Type of material

• NBR (Nitrile rubber)

3- Material thickness

• =0,3 mm

4- Breakthrough times of the glove material

• >480 minutes (permeation: level 6)

5- other protection measures

• Take recovery periods for skin regeneration.
• Preventive skin protection (barrier creams/ointments) is recommended.

6- Respiratory protection

• Dust/Gas Respirators

GST Note: GST is included in the price of this item. GST is included in the freight.